PIC32 UART Interrupt example Project using MPLAB Harmony

A step by step PIC32 UART interrupt example guide to learn how to use MPLAB Harmony

Build and Compile

The next step is to build/compile the application. To do that, click the Build button.

If everything is ok, you should see Build Successful message in the output window.

Program the Device

Now connect your PIC programmer like PICKIT 3 or similar programmer to the PIC32 ICSP header port and USB to the computer USB. Then click on the Make and Program Device Main project button on the toolbar as shown below. If everything is ok then you should see message Programming/Verify complete message in the output window.

What do you think?

0 points
Upvote Downvote

Total votes: 0

Upvotes: 0

Upvotes percentage: 0.000000%

Downvotes: 0

Downvotes percentage: 0.000000%

Leave a Reply

Your email address will not be published. Required fields are marked *

pic32MX break out board assembly

PIC32MX microcontroller LED blinking C program

Fabricating Printed Circuit Boards

Fabricating Printed Circuit Boards